Copyright Encyclopedia

American Water Works Association documents
titleNumber of documents
A collection of Connecticut selected jury instructions, Golf swing trainer, Tell me, dear Lord30
All the windows in the neighborhood (were open) Words & music: Bennie Benjamin & Sol Marcus29
American National Standard for ductile-iron compact fittings, 3 in. through 24 in. (76 mm through 610 mm) and 54 in. through 64 in. (1,400 mm through 1,600 mm), for water service30
American National Standard for ductile-iron compact fittings, 3 in. through 24 in. (76 mm through 610 mm) and 54 in. through 64 in. (1,400 mm through 1,600 mm), for water service part 230
American National Standard for ductile-iron compact fittings, 3 in. through 24 in. (76 mm through 610 mm) and 54 in. through 64 in. (1,400 mm through 1,600 mm), for water service part 330
American National Standard for rubber-gasket joints for ductile-iron and gray-iron pressure pipe and fittings30
American national standard requirements for underground-type three-phase distribution transformers, 2500 kVA and smaller, high voltage 24 940GrdY/14 400 volts and below, low voltage 480 volts and below part 530
American Water Works Association proceedings, 1992 Distribution System Symposium, September 13-16, 1992, Philadelphia, Pa26
A sociocultural perspective of teacher knowledge construction while researching concerns of practice during the professional learning program of teaching as intentional learning30
AWWA Seminar on Engineering Considerations for Granular Activated Carbon (GAC) Treatment Facilities29
AWWA Seminar on Influence of Coagulation on the Selection, Operation, and Performance of Water Treatment Facilities part 230
AWWA standard for asbestos-cement distribution pipe, 4 inches through 16 inches (100 millimeters through 400 millimeters) N P S, for water and other liquids30
AWWA standard for asbestos-cement distribution pipe, 4 inches through 16 inches (100 millimeters through 400 millimeters) N P S, for water and other liquids part 330
AWWA standard for asbestos-cement distribution pipe, 4 inches through 16 inches (100 millimeters through 400 millimeters) N P S, for water and other liquids part 430
AWWA standard for cold-applied petrolatum tape and petroleum wax tape coatings for the exterior of special sections, connections, and fittings for buried steel water pipelines30
AWWA standard for cold-applied petrolatum tape and petroleum wax tape coatings for the exterior of special sections, connections, and fittings for buried steel water pipelines part 230
AWWA standard for heat-shrinkable cross-linked polyolefin coatings for the exterior of special sections, connections, and fittings for steel water pipelines ANSI/AWWA C216-8930
AWWA standard for Polyethylene-aluminum-9olyethlene & crosslinked polyethylene-aluminum-crosslinked polyethylene composite pressure pipes, 1/2 in. (12 mm) through 2 in. (50 mm) for water service30
AWWA standard for Polyethylene-aluminum-9olyethlene & crosslinked polyethylene-aluminum-crosslinked polyethylene composite pressure pipes, 1/2 in. (12 mm) through 2 in. (50 mm) for water service part 230
AWWA standard for Polyethylene-aluminum-9olyethlene & crosslinked polyethylene-aluminum-crosslinked polyethylene composite pressure pipes, 1/2 in. (12 mm) through 2 in. (50 mm) for water service part 330
AWWA standard for Polyethylene-aluminum-9olyethlene & crosslinked polyethylene-aluminum-crosslinked polyethylene composite pressure pipes, 1/2 in. (12 mm) through 2 in. (50 mm) for water service part 430
AWWA standard for the selection of asbestos-cement transmission and feeder main pipe, sizes 18 in. throug 42 in. (450 mm through 1050 mm)30
AWWA standard for the selection of asbestos-cement transmission and feeder main pipe, sizes 18 in. throug 42 in. (450 mm through 1050 mm) part 230
AWWA standard practice for the selection of asbestos-cement transmission and feeder main pipe, sizes 18 in. through 42 in. (450 mm. through 1050 mm.)30
AWWA standard practice for the selection of asbestos-cement transmission and feeder main pipe, sizes 18 in. through 42 in. (450 mm. through 1050 mm.) part 230
Cement mortar lining of water pipelines in place--4 in. (100mm) and larger (ANSI/AWWA C602-06)30
Cement mortar lining of water pipelines in place--4 in. (100mm) and larger (ANSI/AWWA C602-06) part 230
Daywear standards for the successful Washington man, vol. 1, no. 1, Nov. 25, 1991 part 330
Discovery of the Ark of Covenant, Red Sea zone, August 10, 1988, fall, Proof, The Role of nonprofit corporations in urban development26
Erratum to ANSI/AWWA C905-97, Standard for polyvinyl chloride (PVC) pressure pipe and fabricated fittings, 14 in. through 48 in. (450 mm through 1,200 mm), for water transmission and distribution30
Erratum to ANSI/AWWA C905-97, Standard for polyvinyl chloride (PVC) pressure pipe and fabricated fittings, 14 in. through 48 in. (450 mm through 1,200 mm), for water transmission and distribution part 230
Erratum to ANSI/AWWA C905-97, Standard for polyvinyl chloride (PVC) pressure pipe and fabricated fittings, 14 in. through 48 in. (450 mm through 1,200 mm), for water transmission and distribution part 330
Factors affecting disinfection by-product formation during chloramination subject area--water treatment30
Factors affecting disinfection by-product formation during chloramination subject area--water treatment part 230
Factors affecting disinfection by-product formation during chloramination subject area--water treatment part 330
Factors affecting disinfection by-product formation during chloramination subject area--water treatment part 430
Guidance manual for compliance with the filtration and disinfection requirements for public water systems using surface water sources for Science and Technology Branch, Criteria and Standards Division, Office of Drinking Water, US Environmental Protection Agency, Washington, DC30
Guidance manual for compliance with the filtration and disinfection requirements for public water systems using surface water sources for Science and Technology Branch, Criteria and Standards Division, Office of Drinking Water, US Environmental Protection Agency, Washington, DC part 230
Guidance manual for compliance with the filtration and disinfection requirements for public water systems using surface water sources for Science and Technology Branch, Criteria and Standards Division, Office of Drinking Water, US Environmental Protection Agency, Washington, DC part 330
How much is enough? Using financial aid to maximize net tuition revenue, Hazards in the dual banking system27
Identifying geographic regions for potential future epidemiology research on disinfection byproducts30
Identifying geographic regions for potential future epidemiology research on disinfection byproducts part 230
Implementation of arsenic treatment systems, pt. 2, Design considerations, operation and maintenance26
Journal, Louisiana State Medical Society, Journal21
Model, actress, president ... whatever, Caution, Freestylin'30
November 2001 teleconference distribution system repair, rehabilitation and replacement27
Pagan activities during the reigns of Valens and Theodosius I according to the church historians Socrates, Sozomen and Theodoret30
Perceived attitudes toward prescribed HIV/AIDS medication adherence in African American, Caucasian, and Hispanic populations in the Black Belt region of Alabama30
Performance feedback and generalization programming in writing instruction, Basic science experiences30
Photoluminescence studies of indium-phosphide, DTWD demo tape II, DTWD project IV29
Preparation of hydrogenated amorphous silicon and its characterization by transient photoconductivity part 430
Qualserve performance indicators, water and wastewater utilities pilot survey, final report, Mar. 200330
Removal of soluble manganese from water by oxide-coated filter media/ prepared by William R. Knocke, Suzanne Occiano, Robert Hungate ; prepared for AWWA Research Foundation30
Removal of soluble manganese from water by oxide-coated filter media/ prepared by William R. Knocke, Suzanne Occiano, Robert Hungate ; prepared for AWWA Research Foundation part 230
Removal of soluble manganese from water by oxide-coated filter media/ prepared by William R. Knocke, Suzanne Occiano, Robert Hungate ; prepared for AWWA Research Foundation part 330
Sales technology, relationship-forging tasks, and sales performance in business markets30
Seismic analysis of safety-related nuclear structures and commentary on standard for seismic analysis of safety related nuclear structures30
Stainless-steel fittings for waterworks service, sizes 1/2 in. through 72 in. (13mm through 1,800 mm)30
The effect of providing feedback on the characteristics of student responses to a videotaped format for high school physics assessment part 229
The selection of asbestos-cement transmission pipe, sizes 18 inches through 42 inches (450 millimeter through 1,050 millmeter) for water supply service30
The selection of asbestos-cement transmission pipe, sizes 18 inches through 42 inches (450 millimeter through 1,050 millmeter) for water supply service part 230
The selection of asbestos-cement transmission pipe, sizes 18 inches through 42 inches (450 millimeter through 1,050 millmeter) for water supply service part 330
Upgrading and retrofitting water and wastewater treatment plants WEF manual of practice number 28 part 230
Yes, you can still order the exclusive Fruit-of-the Month Club for Christmas by telephone, toll free part 230
This website is not affiliated with document authors or copyright owners. This page is provided for informational purposes only. Unintentional errors are possible. Multiple persons can share the same name.